1820B58 CLUTCH HYDRAULIC CIRCUIT VIBRATION DAMPER - R+R - Fiat - STILO - eLearn

3362742 - 1820B58 clutch hydraulic circuit vibration damper - r+r

) Place the car on a lift. - 5530B56 BATTERY DRIP TRAY COVER - R.R.- 5530B10 battery - r+r - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.Remove the protective cap from the bleed valve of one front brake caliperConnect the collection system (pipe and reservoir) to the bleed valve on the brake caliper.Operate the brake pedal until the brake-clutch fluid reservoir is empty.1. Lift the clip (1a) and release the hydraulic clutch release actuator pipe (1b).

Collect the fluid in a suitable container.

Release the pipe from the fastening clip on the engine support.

1. Open the band and release the clutch-brake fluid reservoir pipe.2. Retract the clip (2a) and remove the vibration damper from the clutch pump (2b) complete with hydraulic clutch release actuator and pipe (2c).

Refitting ( Removing

) Position the damper and the hydraulic clutch release actuator and pipe. Pull the retaining clip back and fit the vibration damper in its seat on the clutch pump.Position the pipe from the brake-clutch fluid reservoir and secure it to the damper using the special band.Connect the hydraulic clutch release actuator pipe and secure it to the engine support using the special clip.Lock the hydraulic clutch release actuator using the special fastenings.

Do not use detergents or mineral lubricants incompatible with the brake fluid materials.

Tighten the connector of the rigid section of the pipe from the slave cylinder. - 0010T67 hydraulic clutch system bleed air - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. . - 5530B10 battery - r+r . - 5530B56 BATTERY DRIP TRAY COVER - R.R. . Remove the vehicle from the ramp.