7045D21 FRONT SEAT CUSHION COVER, LEFT OR RIGHT - R.R. WITH SEAT REMOVED - Fiat - STILO - eLearn

3363428 - 7045D21 Front seat CUSHION COVER, left or right - R.R. with seat removed

) - 7045A24 squab knob - r r - 7045A52 squab rake adjustment device outer guard one lh or rh r r - 7045A54 squab rake adjustment device inner guard one lh or rh r r - 7045A44 seat interior guard - r r - 7045A43 seat exterior guard - r rFold the front seat over so that the side cover fixing bolts are accessible.1. Undo the front (1a) and lower (1b) fixing bolts.2. Release the outer cover from the housing and remove it.

1. Undo the front (1a) and side (1b) fixing bolts.2. Release the inner cover from the housing and remove it.

Fold the front seat over so that the bolts fixing the glove compartment support are accessible.1. Undo the front (1a) and rear (1b) fixing bolts.2. Release the electrical wiring (2a) from the retaining springs (2b) on the glove compartment support.

1. Release the glove comparemtnt support from the housing and remove it.

Remove the front seat glove compartment from the housing.1. Release the flexible rods for the cushion cover from the fastenings

Fold the front seat over so that the fastenings securing the cushion cover to the cushion frame are accessible.1. Using a suitable tool, release the rear cushion cover (1a) fastened to the frame flange (1b).

1. Release the cushion cover retaining springs fastened to the cushion frame.

1. Release the cover (1a), along the entire perimeter, from the retaining hooks (1b) on the cushion frame.

1. Separate the cover (1a) from the upholstery (1b).

The cover is fastened to the upholstery using velcro.

Refitting ( Removing

) Check that the trim is undamaged.If this is not the case, replace the cover.Position the cover on the upholstery, matching up the velcro on the two edges.1. Fit the coer (1a), along the entire perimeter, to the retaining hooks (1b) on the cushion frame.

1. Attach the cushion cover retaining springs, fastened to the cushion frame.

1. Fit the rear cushion cover (1a) to the frame flange (1b).Use a rubber hammer on the cover surround to ensure that it is perfectly fitted to the cushion frame flange.

1. Secure the cushion cover flexible rods to the fastenings.

Mould the cover onto the padding.Fit the glove compartment housing in place and secure it using the bolts.Fit the outer cover in position and tighten the fixing bolts.Fit the inner cover in position and tighten the fixing bolts.Fit the glove compartment in the housing in the front seat. - 7045A43 seat exterior guard - r r - 7045A44 seat interior guard - r r - 7045A54 squab rake adjustment device inner guard one lh or rh r r - 7045A52 squab rake adjustment device outer guard one lh or rh r r - 7045A24 squab knob - r r