3362364 - 0010T12 ENGINE OIL AND FILTER - REPLACE

Position the vehicle on the rampRemove the filler plug.Withdraw the oil level dipstick.Raise the car.Place a suitable container under the car, level with the drain plug.Undo the drain plug on the engine sump and drain the oil completely into the container.

Be very careful whilst removing the drain plug; the oil could be very hot.

Do not disperse the oil into the environment, as indiscriminate dispersal of this product causes pollution.

Clean the drain plug and tighten it to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Plug	ENGINE OIL DRAIN PLUG	M18 x 1.5	2

Lubricate the new oil filter gasket with engine oil and tighten it fully.Refill the engine lubrication circuit using the recommended oil.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE OIL AND FILTER	SELENIA 20K	2.8

The table shows the quantity for periodic replacement.

For the optimum operation of the engine in particularly harsh climatic conditions (temperatures below -15 degrees C), use the recommended oil for the engine lubrication circuit.

	Type	Component	Name	Qty.
-	Oli [l]	ENGINE OIL AND FILTER	SELENIA PERFORMER	2.8

The table shows the quantity for periodic replacement.

Check that the engine oil level on the dipstick is correct (    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY).Fit the filler plug.Start up the enigne and let it idle for about two minutes; Switch off the engine and wait for a few minutes.Check that the engine oil level on the dipstick is correct (    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY).Remove the car from the ramps.