5580C44 FRONT SIDE BAG MODULE ONE LH OR RH R R - Fiat - STILO - eLearn

3363155 - 5580C44 front side bag module one lh or rh r r

Before proceeding with the operations of dismantling the side Air Bag module, the following preliminary operations must be carried out: - Turn the ignition key to the OFF position; - Disconnect the battery leads and insulate them; - Wait for 10 minutes before continuing.

FOLLOW ALL THE RECOMMENDED SAFETY RULES CLOSELY (See assembly 5508C - AIR BAG SYSTEM)

Removing ( Refitting

) - 7045A24 squab knob - r r - 7045A52 squab rake adjustment device outer guard one lh or rh r rDisconnect the battery negative terminal. - 5530B56 BATTERY DRIP TRAY COVER - R.R. - 7045A10 l/h or r/h front seat (one) - r+rCompletely lower the cushion using the special lever.1. Separate the backrest cover surround (1c) along the sides (1a) and (1b) from the oddments pocket surround (1d).

1. Open the oddments pocket.

1. Side Air Bag module side, release the backrest cover surround from the frame using a knife.

	Name	Country
-	Scraper blade	1.878.077.000

Disconnect the side Air Bag electrical connector.

	Name	Connector
-	Driver's Side>Bag	Q30

	Name	Connector
-	Passenger Side Bag	Q31

1. Undo the fixing nuts (1a) and remove the side Air Bag module from the housing.

Place the Air Bag module in the special cupboard, resting it on a free surface with the flat surface facing upwards.

Refitting ( Removing

)

Handle the side Air Bag with extreme caution. Ensure the battery is disconnected.

If a new module is being fitted, attach the labels as described below.Detach the removable part of the adhesive label from the new module. Place a copy of the label in a specific file containing the vehicle details (model, registration data, chassis number) and the serial number of the old module. This file should be kept for future checks. Apply the detachable part of the original label to the bottom of the seat, where there are already similar labels for the seat, squab cover and Air Bag wiring.

Any impacts could distort the front seat frame. Proceed as follows to check frame condition.

Check visually for deformation or cracks in the seat frame.Check that the impact slots on the lower sides of the squabs are not deformed.Check that the backrest/cushion join welding is intact.Check the squab for torsional deformation by measuring the diagonals of the squab frame.Check that the measurements are the same and that the diagonals intersect at the centre of the squab.Move the seat through all its various settings to ensure that movements take place without binding or noise.

If the checks have a favourable result, only the damaged components need be replaced (Air Bag module, electrical wiring, cover ...).

Place the Air Bag module in position and tighten the fixing bolts to torque.Connect the side Air Bag module electrical connector.

	Name	Connector
-	Driver's Side>Bag	Q30

	Name	Connector
-	Passenger Side Bag	Q31

1. Working on the side Air Bag module side, fit the backrest cover surround on the frame.Using a rubber hammer, ensure that the cover surround is correctly fitted on the actual surround of the frame flange.

Close the oddments pocket.1. Fit the backrest cover surround (1c) along the sides (1a) and (1b) onto the oddments pocket surround (1d).

- 7045A10 l/h or r/h front seat (one) - r+r - 5530B56 BATTERY DRIP TRAY COVER - R.R.Connect the battery negative terminal. - 7045A52 squab rake adjustment device outer guard one lh or rh r r - 7045A24 squab knob - r r