3363248 - 7010A14 rear side door - adjust centering and moulding - includes adaptation of hinges and seals on door compartment

Look to ensure the gap between door and exterior profile is even.

1. Loosen the retaining bolts of door check strap (1c) on the body side (1a) and door side (1b). To adapt the door transversally to the door seal, carry out the operations below.1. Slacken the bolts (1a) securing the door striker (1b). 1. Slacken the bolts (1a), door side, securing the door hinge (1b).

It is advisable to work on one hinge at a time.

After adjustment, tighten the door hinge bolts and door catch striker bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	STRIKER ON REAR SIDE DOOR PILLAR	M8	2.4

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SIDE DOOR HINGES	M8	3

Proceed as follows to adjust the door in longitudinal and vertical directions.1. Slacken the bolts (1a), bodywork side, securing the door hinge (1b).

It is advisable to work on one hinge at a time.

On completion of adjustment, tighten the door hinge bolts to torque on the body side.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SIDE DOOR HINGES	M8	(Outside of bodyshell) 3.2

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR SIDE DOOR HINGES	M8	(Internal bodyshell side) 3

1. The figure shows the possible movements of the hinge for the transversal adaptation of the door to the door seal (1a), via the slotted hole (1b), for adjustment in the vertical direction (1c) and longitudinal direction (1d) through the slotted holes (1e). At the end of each adjustment, tighten the door check strap bolts to torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR DOOR OPENING LIMITER	M6	1.2