3363847 - Introduction - BRAKING SYSTEM
CAUTION
All operations should be carried
out taking great care to avoid injury to persons.The engine compartment contains numerous
moving parts, components at high temperatures and electrical wiring
with voltage.Follow these precautions scrupulously
when carrying out operations in the engine compartment:
- Turn off the engine and wait for it to cool down.
- do not smoke.
- Do not use naked flames.
- Make sure that there is a fire extinguisher in the vicinity.
For some procedures, the use of special
tools is indicated. The use of these tools is vital in order to
work safely.Follow the safety instructions in force
for workshop procedures. Where necessary, the Manual contains specific warnings
to prevent the risk of dangerous situations.When using chemicals, closely follow the
safety instructions given on the safety sheet which the supplier
must give the user.The electronic ignition system generates
voltages of 20,000 V and higher which could be very dangerous to people,
especially if they suffer from a heart condition. Great care should
be taken when working on this system or near its components.WARNINGS
All the operations must be carried
out with the utmost attention and care to avoid damaging the components.Prevent brake-clutch fluid coming into contact
with painted parts; If this should happen, wash immediately with
water.Do not reuse brake-clutch fluid drained
during bleeding.Before any interventions on electrical components, including
battery disconnection, make sure that the ignition is off ('STOP'
position).In order to release parts which are sticking,
tap lightly using an aluminium or lead hammer for ferrous materials, and
a wooden or resin hammer for light alloy parts.During dismantling, check that parts which
have to be marked carry reference marks.When refitting, lubricate the parts, where
necessary, to prevent sticking or seizing during the initial operating period.
During refitting, it is essential to observe the tightening torques
and adjustment data.During each refitting, replace the gaskets,
oil seals, spring washers, safety plates, self-locking nuts, pre-treated
bolts and all components which have deteriorated.The replacement of removed assemblies or
components should be carried out using genuine spare parts only:
this is the only way that the interchangeability and perfect operation
of the various components can be guaranteed.