3362881 - 3340B52 pump/central obs pipe - r r
Removing
(
Refitting
)
- 5530B56 BATTERY DRIP TRAY COVER
- R.R.
1. Undo the fixing bolt (1a) from the junction unit (1b) and move
it aside.
 | Name | Country |
|---|---|---|
| - | Spanner | 1.856.127.000 |
| Name | Country |
|---|---|---|
| - | Spanner | 1.856.127.000 |
Refitting
(
Removing
)
Fit the rigid pipe from the
master cylinder to the electrohydraulic unit.Using the special tool, tighten up the
nuts securing the rigid pipe to the brake servo pump master cylinder. | Name | Country |
|---|---|---|
| - | Box wrench for brake fittings | 1.856.132.000 |
| Name | Country |
|---|---|---|
| - | Spanner | 1.856.127.000 |
Removing
(
Refitting
)
- 1016A10 sound-proofing cover - r + rRemove the protective cap from the bleed
valve of one front brake caliperConnect the collection system (pipe and
reservoir) to the bleed valve on the brake caliper. Operate the brake pedal until the brake-clutch
fluid reservoir is empty. 1. Undo the connectors and disconnect the rigid pipe from the master
cylinder and from the ABS control unit.2. Remove the rigid pipe from the master cylinder (pump) to the
ABS hydraulic control unit. | Seal the oil pipe threaded seats. |
Refitting
(
Removing
)
Fit the rigid pipe from the master cylinder
(pump) to the ABS hydraulic control unit. | The protection for the threaded seats should only be removed when fitting the brake pipes to prevent possible impurities from being introduced into the control unit. |
 | Fastening | Component | Ø | Value(daNm) |
|---|---|---|---|---|
| - | - | PIPE FROM PUMP TO HYDRAULIC CONTROL UNIT | M10 | 16 |