3362888 - 3340B80 RIGHT RIGID PIPE FROM PIPE CONNECTOR ON REAR SUSPENSION AXLE - R.R.

Removing ( Refitting ) Position the vehicle on the ramp. - 7055B81  ANY (ONE) UNDERBODY PROTECTION FOR BRAKING/FUEL SYSTEM - R.R . (right and left) - 1076A44 intermediate exhaust silencer rear heat shield r r 1. Place a hydraulic jack under the fuel tank.2. Undo the bolts (2a) fixing the front tank supporting bands, and lower the tank (2b).
Check that the electrical wiring for the fuel pump immersed in the tank is not live.
1. Using the special tool, disconnect the rigid pipe from the intermediate connector.

NameCountry
-Box wrench for brake fittings1.856.132.000
using the special tool, disconnect the rigid pipe from the intermediate hose on the rear axle.

NameCountry
-Box wrench for brake fittings1.856.132.000
Release the rigid pipe from the retaining clips present on the whole of its length.1. Remove the rigid pipe from the connector to the rear intermediate hose.
Refitting ( Removing ) Position the rigid pipe from the connector to the rear intermediate hose.Secure the pipe to the retaining clips present throughout its whole length.Using the special tool, connect the rigid pipe to the intermediate hose on the rear axle.

NameCountry
-Box wrench for brake fittings1.856.132.000
Using the special tool, connect the rigid pipe to the intermediate connector.

NameCountry
-Box wrench for brake fittings1.856.132.000
Raise the hydraulic jack until the tank is in the correct position.Tighten the bolts securing the front tank support bands.Lower the hydraulic jack and remove it.- 1076A44 intermediate exhaust silencer rear heat shield r r  - 7055B81  ANY (ONE) UNDERBODY PROTECTION FOR BRAKING/FUEL SYSTEM - R.R . (right and left) Remove the vehicle from the ramp.