3362929 - 4410C10 front suspension stabilizer bar - r+r - check wheel geometry separately

Removing ( Refitting ) Place the car on a lift. - 5530B56  BATTERY DRIP TRAY COVER - R.R.Disconnect the battery negative terminal. - 4450B12  front or rear wheels (two) - r+r - 7055B54  under-engine guard - r r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1072C16  exhaust manifold with catalytic converter - r r 1. Undo the fixing nuts (1a) and disconnect the exhaust pipe (1b) from the manifold (1c).
Refitting ( Removing ) Position the antiroll bar.Tighten the nuts of the shock absorber link on the anti-roll bar.

FasteningComponentØValue(daNm)
-NutFRONT ANTI-ROLL BAR. ANCHORAGE ROD.M10 x 1.255
Raise the hydraulic jack, bringing the crossmember against the bodyshell.Tighten to torque the bolt securing the bottom reaction rod.

FasteningComponentØValue(daNm)
-BoltREACTION RODM1212
Tighten to torque the bolts securing the crossmember to the bodyshell.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM1415
Tighten to torque the bolts securing the steering box to the crossmember.

FasteningComponentØValue(daNm)
-NutENGINE OR ROD ANCHORAGE BEAMM12 x 1.258,5
Tighten to torque the bolts securing the anti-roll bar.

FasteningComponentØValue(daNm)
-BoltFRONT ANTI-ROLL BARM82,5
Position the exhaust pipe on the manifold and tighten the fixing nuts to the recommended torque.

FasteningComponentØValue(daNm)
-NutEXHAUST PIPE TO ENGINEM82.5