3362501 - 1080E62 pipe from fuel vapour separator to solenoid - r r

Removing ( Refitting )  - 1016A10  sound-proofing cover - r + r1. Disconnect the rapid attachment coupling for the fuel vapour recover pipe from the solenoid.Release the pipe from the clips securing it to the bulkhead. Raise the car.1. Undo the fixing bolts (1a) and remove the tank right side shield (1b). 1. Disconnect the quick-fit connector on the pipe between the solenoid and active charcoal filter. 1. Undo the fixing bolts (1a) and remove the fuel and anti-evaporation pipe guard (1b). 1. Release the anti-evaporation pipe (1a) from the clips (1b) located under the body. 1. From the top of the engine compartment, remove the anti-evaporation pipe complete with vapour recovery solenoid. Refitting ( Removing ) Working from the bottom of the car, fit the pipe complete with solenoid, partially raise the ramp and fit the anti-evaporation pipe back in its housing.Attach the pipe to the retaining clips on the underbodyConnect the anti-evaporation pipe to the quick-fit connector with the rear section connecting to the active charcoal filter.Fit lower pipe guard and tighten the retaining bolts.Fit the right side tank guard and tighten the retaining bolts.Lower the vehicle.Connecct the rapid connector for the fuel vapour recovery pipe to the solenoid.Secure the pipe to the bulkhead. - 1016A10  sound-proofing cover - r + r