3362882 - 3340B55 central brake pipe to lh - r r

Removing ( Refitting ) Place the car on a lift. - 4450B02  left front wheel r r1. Disconnect the flexible pipe (1a) from the rigid pipe (1b) using the special tool, and release the retaining clip (1c).

NameCountry
-Box wrench for brake fittings1.856.132.000
1. Undo the bolts (1a) fixing the pump master cylinder (1b) and move it aside as far as possible.Remove the rigid pipe from hydraulic control unit to front left brake.
Refitting ( Removing ) Fit the rigid pipe from the hydraulic control unit to the front left brake. Tighten the bolts securing the pump master cylinder. Removing ( Refitting ) Place the car on a lift. - 4450B02  left front wheel r r - 7055B54  under-engine guard - r r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R.Remove the protective cap from the bleed valve of one front brake caliperConnect the collection system (pipe and reservoir) to the bleed valve on the brake caliper. Operate the brake pedal until the brake-clutch fluid reservoir is empty. 1. Disconnect the flexible pipe (1a) from the rigid pipe (1b) and release the retaining clip (1c).
 - 1016A10  sound-proofing cover - r + r- 5530B10 battery - r+r  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.Release the rigid pipe from the clips fixing it to the bodywork.1. Undo the connector and disconnect the rigid pipe on the electro-hydraulic control unit.
Seal the oil pipe threaded seats.
Remove the rigid pipe from hydraulic control unit to front left brake.
1. Undo the bolts (1a) fixing the pump master cylinder (1b) and move it aside as far as possible.Remove the rigid pipe from hydraulic control unit to front left brake.
Refitting ( Removing ) Fit the rigid pipe from the hydraulic control unit to the left front brake.Tighten the nuts fixing the pump master cylinder tightening them to the recommended torque.

FasteningComponentØValue(daNm)
-NutCLUTCH FLUID MASTER CYLINDERM82.2
Fit the rigid pipe from the hydraulic control unit to the left front brake.
The protection for the threaded seats should only be removed when fitting the brake pipes to prevent possible impurities from being introduced into the control unit.
Tighten the connector and connect the rigid pipe to the electro-hydraulic control unit.

FasteningComponentØValue(daNm)
-Male connectorABS CONTROL UNIT RIGID FRONT BRAKE PIPES../M1016
Secure the rigid pipe to the fastening clips on the bodyshell. - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r  - 1016A10  sound-proofing cover - r + rConnect the flexible pipe to the rigid pipe and secure the retaining clip. - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 7055B54  under-engine guard - r r - 4450B02  left front wheel r rRemove the vehicle from the lift. - 0010T64  brake and or clutch fluid check level and top up as necessary - 0010T65  hydraulic brake system bleed air