3360294 - K110 ENGINE OIL LEVEL INFORMATION INCORRECT
The low engine oil level information shown on the display does not correspond to measurements made using the dipstick. | Engine oil level information is managed by the Instrument Panel Node via an oil level sensor on the engine and connected directly to the Instrument Panel Node |
| Results of the tests | ||||
| 0 | PRELIMINARY CHECK | All OK | Problems met | Operation |
|---|---|---|---|---|
| Check that no oil level sensor fault message is present on the reconfigurable display | Continue to Step 2 | Oil sensor fault message present | Continue to Step 1 | |
| 1 | CHECK WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
Connect an Examiner to the tester input and check the body computer node for:
| Continue to Step 4 | Error in the oil sensor | Continue to Step 2 | |
| 2 | OIL LEVEL CHECK | All OK | Problems met | Operation |
| Check that the oil level sensor is working properly See Test 5560BO Check on engine oil level sensor operation | Continue to Step 3 | Oil level sensor fault | change sensor Op. 1084A40 | |
| 3 | CHECKING ELECTRICAL EQUIPMENT | All OK | Problems met | Operation |
| Check the continuity and the insulation of the wires between sensor and instrument panel | Continue to Step 4 | Wiring broken or not insulated | Renew the electrical connections See E4010 INSTRUMENT PANEL | |
| 4 | CHECK CORRECT OPERATION | All OK | Problems met | Operation |
| Check that the fault is no longer present | End of diagnosis | Fault persists | Replace instrument panel Op. 5560B11Search for the fault starting from another symptom' | |