3362661 - 1060F10 fuel injectors

Removing ( Refitting )  - 1016A10  sound-proofing cover - r + r - 1060F36  lines to injectors - r rDisconnect the pipe from the injectors to the fuel recovery manifold from the manifold and injectors.Disconnect the injector electrical connections

NameConnector
-Injector  N70 
1. Undo the injector anchoring brackets securing nuts.2. Fit injector removal device (2a). Ensure lifting bracket (2b) is fitted beneath the polygonal area of the injector.3. Fit the second lifting bracket (3a) of the device under injector securing bracket (3b).4. Tighten device nut (4a) and remove the injector (4b).Repeat the operation for the remaining injectors.

NameCountry
2aExtractor1.870.739.000
Refitting ( Removing ) Check the injectors are in good condition.

The injectors have been graded to improve engine operation and guarantee emission limits are respected in the long term. When replacing the injectors, note the following:

  • The Bosch part number and injector category is engraved on the upper part of the magnet on each injector (1,2,3 inside a ring). This is determined on the basis of fuel quantity injected into the emission control point.
  • The graded injectors described above are complemented by a new injection control unit that is personalized according to the injector category
The modification will be implemented from October 2001 from engine no. 2805542.If a premodification engine injector is replaced, fit parts marked with the code C5603 and do not work on the injection control unit.When replacing post-modification injectors, order parts identified as D5303 and no. 73501139. These parts are category 2C and require a specific injection control unit customisation procedure. This procedure is carried out using an Examiner diagostic tester and using the controls in the active Injector Classification function.Fit the injectors complete with bracket.Tighten the fixing nuts to torque.

FasteningComponentØValue(daNm)
-NutINJECTORS(DIESEL)M8 x 1.253
Fit the injection wiring and tighten the fixing bolts.Connect the electrical connections to the injectors.

NameConnector
-Injector  N70 
Connect the pipe clips to the injectors and connect the pipe to the return manifold. - 1060F36  lines to injectors - r r - 1016A10  sound-proofing cover - r + r