3362800 - 2710A10 drive shaft with joints (one), l/h or r/h - r + r

Removing ( Refitting ) Place the car on a ramp. - 4450B10  Front WHEEL (one) - R.R. - 7055B54  under-engine guard - r r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R.1. Unscrew the retaining nut.2. Using the tool (2a), release the steering track rod end (2b) from the housing in the steering knuckle.

	Name	Country
2a	Extractor	1.871.000.700

1. Relieve the staking on the nut securing the drive shaft to the wheel hub, then unscrew it.2. Undo the bolts securing the vertical link to the suspension.Move the drive shaft constant velocity joint away from the wheel hub.3. Undo the bolts fixing the driveshaft to the intermediate shaft, then remove the actual driveshaft. Refitting ( Removing ) Fit the drive shaft in its seat in the car.Tighten the bolts securing the drive shaft to the intermediate shaft.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	FRONT DRIVE SHAFT COMPLETE WITH JOINTS	M6	1

Fit the constant velocity joint onto the wheel hub.Tighten the bolts securing the suspension vertical link to the shock absorber to the specified torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT DAMPER	M10 x 1.25	(Steering knuckle) 7

Tighten the nut fixing the hub to the steering knuckle.1. Using a hammer and chisel, stake the nut securing the drive shaft to the wheel hub, working as shown in the figure.Then tighten the nut to torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	FRONT HUB WITH BEARINGS	M24	7 + 62°

 - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 7055B54  under-engine guard - r r - 4450B10  Front WHEEL (one) - R.R.Remove the vehicle from the lift.