2110C54 GEAR SELECTION AND ENGAGEMENT UNIT - R R - Fiat - STILO - eLearn

3363588 - 2110C54 gear selection and engagement unit - r r

) 1. Remove the O-ring.Position the gear selector and engagement assembly in the vice fitted with protective jaws.2. Lift up the rubber protection.3. Lift up the selector to release it from the control shaft.Remove the gear selector and engagement assembly from the vice.

1. Remove the retaining ring.2. Remove the pin.

1. Remove the selector (1a) and the bracket (1b).2. Remove the cover.3. Remove the springs.4. Remove the bush.5. Remove the mount.6. Remove the flange.7. Separate the rubber protection (7a) from the control shaft (7b).

Position the support in the vice fitted with protective jaws.1. Undo the nut (1a) and remove the spring (1b).Remove the support from the vice.

1. Remove the bush.2. Remove the selector.3. Remove the lever.4. Remove the two bushes.5. Remove the seal (5a) and the bush (5b) using a suitable tool (5c).

Reassembling ( Dismantling

) 1. Fit the bush (1a) and the seal (1b) using a suitable tool (1c).2. Fit the two bushes.3. Fit the lever.4. Fit the selector.5. Fit the bush.

Position the support in the vice fitted with protective jaws.Fit the spring and tighten the nut.Remove the support from the vice.Fit the rubber protection on the control shaft.Fit the flange.Fit the support.Fit the bush.Fit the springs.Fit the cover.1. Fit the selector (1a) and the support (1b) as shown in the diagram.

Fit the pin.Fit the retaining ring.Fit the gear selector and engagement assembly in the vice fitted with protective jaws.Connect the selector to the control shaft.Fit the rubber protection.Remove the gear selector and engagement assembly from the vice.Fit a new O-Ring seal.