3360173 - A33 ALARM ACTIVATION ACOUSTIC SIGNAL IRREGULAR

Problems with alarm system activation (door/s and/or boot open) are indicated by a warning beep.
The system automatically cuts out perimeter protection for door/s and/or boot if they are not properly closed.
Results of the tests
1CHECKING WITH DIAGNOSTIC EQUIPMENTAll OKProblems metOperation
Connect the Examiner tester and check that door and boot lid status (open/closed) is correctly received while in parameter mode.Continue to Step 4Error in receiving door and boot lid status (open/closed).Continue to Step 2
2CHECKING ELECTRICAL CIRCUITAll OKProblems metOperation
Check continuity/insulation of the connection between the body computer node and door/s and boot lid.Continue to Step 3Electrical connection damaged.Restore continuity/insulation of the damaged electrical connection. See   E7015  ALARM
3CHECKING ELECTRICAL COMPONENT OPERATIONAll OKProblems metOperation
Disconnect the connector on the computer body node side and check for a door open/closed and boot open/closed signal. See   E7015  ALARM Continue to Step 4Status indication switch not working.Change the damaged switch if a front door is affected. Op.   7005N21 
Status indication switch not working.Change the damaged switch if a rear door is affected. Op.   7010N21 
Status indication switch not working.Change the damaged switch if the boot lid is affected. Op. 7025B38
4CHECKING CORRECT OPERATIONAll OKProblems metOperation
Check that the fault is no longer presentEnd of diagnosisFault persistsChange the body computer node Op. 5505A32Search for the fault starting from another symptom'