| | Results of the tests |
| 0 | CARRY OUT CLUTCH PARAMETER CALIBRATION
USING THE EXAMINER | All OK | Problems met | Operation |
|---|
| In
active diagnosis carry out the calibration of the clutch parameters
through the 'clutch self-calibration enablement' with a positive
result | Continue to Step 1 | The calibration is not
successful | Continue in accordance with the instructions for the
diagnostic equipment |
| 1 | CHECK THAT THE FAULT IS NO LONGER
PRESENT | All
OK | Problems
met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | The fault persists | Continue to Step 2 |
| 2 | CHECK THE CLUTCH SENSOR WIRING LAYOUT | All OK | Problems met | Operation |
|---|
| Check
the state of the connections, continuity of the wiring (it is important
to pay particular attention to the layout of the clutch position
sensor wiring in the engine compartment: the wire must not be too
taut, and it must have sufficient slack) | Continue to Step 3 | There is a fault | Repair/replace the part that
is not workingContinue to Step 3 |
| 3 | CHECK THAT THE FAULT IS NO LONGER
PRESENT | All
OK | Problems
met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | The fault persists | Continue to Step 4 |
| 4 | THE FAULT PERSISTS | All OK | Problems met | Operation |
|---|
| Contact
Technical Service for further information on the problem | End of diagnosis | Fault persists | Search for the
fault starting from another symptom' |