3362881 - 3340B52 pump/central obs pipe - r r

Removing ( Refitting )  - 5530B56  BATTERY DRIP TRAY COVER - R.R.  - 1016A40  ignition coil cover on cylinder head- r+r- 5530B10 battery - r+r  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R. - 1056B82  injection/ignition system e.c.u. (one) - r + r- 1056B89 ignition/injection system control unit mount (single) - r r for versions with manual gearbox with hydraulic shift  - 1048A31  RIGID PIPE between air filter and intake manifold - R.R. - 1056B14  throttle case - r + r Refitting ( Removing ) Fit the rigid pipe from the master cylinder to the electrohydraulic unit.Using the special tool, tighten up the nuts securing the rigid pipe to the brake servo pump master cylinder.

NameCountry
-Box wrench for brake fittings1.856.132.000
Using the special tool, tighten the nuts securing the rigid pipe to the electrohydraulic unit.

NameCountry
-Spanner1.856.127.000
 - 1056B14  throttle case - r + r - 1048A31  RIGID PIPE between air filter and intake manifold - R.R.- 1056B89 ignition/injection system control unit mount (single) - r r for versions with manual gearbox with hydraulic shift  - 1056B82  injection/ignition system e.c.u. (one) - r + r - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r  - 1016A40  ignition coil cover on cylinder head- r+r  - 5530B56  BATTERY DRIP TRAY COVER - R.R. - 0010T64  brake and or clutch fluid check level and top up as necessary - 0010T65  hydraulic brake system bleed air Removing ( Refitting )  - 1016A10  sound-proofing cover - r + rRemove the protective cap from the bleed valve of one front brake caliperConnect the collection system (pipe and reservoir) to the bleed valve on the brake caliper. Operate the brake pedal until the brake-clutch fluid reservoir is empty. 1. Undo the connectors and disconnect the rigid pipe from the master cylinder and from the ABS control unit.2. Remove the rigid pipe from the master cylinder (pump) to the ABS hydraulic control unit.
Seal the oil pipe threaded seats.
Refitting ( Removing ) Fit the rigid pipe from the master cylinder (pump) to the ABS hydraulic control unit.
The protection for the threaded seats should only be removed when fitting the brake pipes to prevent possible impurities from being introduced into the control unit.
Tighten the connectors for the rigid pipe to the master cylinder and to the ABS control unit.

FasteningComponentØValue(daNm)
--PIPE FROM PUMP TO HYDRAULIC CONTROL UNITM1016
 - 1016A10  sound-proofing cover - r + r - 0010T64  brake and or clutch fluid check level and top up as necessary - 0010T65  hydraulic brake system bleed air