3362783 - 2127C44 pressure accumulator on hydraulic actuator unit - r r

Removing ( Refitting )  - 5530B56  BATTERY DRIP TRAY COVER - R.R. - 1016A40  ignition coil cover on cylinder head- r+r- 5530B10 battery - r+r  - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.Temporarily refit the battery and reconnect the negative and positive terminals.Turn the ignition ON.Carry out the Selespeed hydraulic circuit depressurisation procedure using an Examiner tester. 1. Disconnect the electrical connection on the hydraulic selection system pump.

	Name	Connector
1	"Selespeed gearbox electric pump"	N47

Disconnect the negative and positive terminals and remove the battery. - 1056B82  injection/ignition system e.c.u. (one) - r + r - 1048A31  RIGID PIPE between air filter and intake manifold - R.R.1. Undo the pressure accumulator and remove it. Refitting ( Removing ) Fit the pressure accumulator and tighten it onto the hydraulic unit. - 1048A31  RIGID PIPE between air filter and intake manifold - R.R. - 1056B82  injection/ignition system e.c.u. (one) - r + rConnect the electrical connection on the hydraulic selection system pump.

	Name	Connector
-	"Selespeed gearbox electric pump"	N47

 - 5530B52  Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r Connect the battery negative terminal. - 0010T47  hydraulic system fluid for gearbox with hydraulic selection check level and top up if necessary- 0010T46 hydraulic system fluid for gearbox with hydraulic selection change  - 1016A40  ignition coil cover on cylinder head- r+r - 5530B56  BATTERY DRIP TRAY COVER - R.R.