5010A12 ENGINE/HEATER LINE - R R - Fiat - STILO - eLearn

3362971 - 5010A12 engine/heater line - r r

) - 5530B56 BATTERY DRIP TRAY COVER - R.R.- 5530B10 battery - r+r - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. - 1016A40 ignition coil cover on cylinder head- r+r - 1056B82 injection/ignition system e.c.u. (one) - r + rMove the electrical connectors aside.- 1048A36 sleeve from flow meter to intake manifold - r + r - 1056B15 throttle body intergral with mds - r r - 1048A23 cold air intake - r r1. Disconnect the flow meter electrical connector.

	Name	Connector
1	Air flow meter	K41

Raise the car on a lift. - 7055B54 under-engine guard - r r - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R.1. Remove the air filter casing.

Lower the car with the lift.Position a suitable container for collecting the coolant fluid.1. Disconnect the lower hose from the radiator acting on the rapid connector and drain the engine cooling system.

1. Disconnect the electrical connector for the coupling for the engine wiring (1a), the water temperature sensor (1b) and the earth on the engine (1c) and move it aside.

	Name	Connector
1a	Front/engine connection	D4A

	Name	Connector
1b	Engine temperature sender unit	K36

	Name	Connector
1c	Earth on engine	C40

Release the pipe from the retaining bands.1. Disconnect the water supply pipe to the heater from the thermostat, breaking the retaining band.Position a suitable container for collecting the coolant fluid.2. Remove the band securing the water supply pipe to the heater to the heater inlet pipe.3. Remove the water supply pipe to the heater.

Refitting ( Removing

) Secure the water supply pipe to the heater to the heater inlet pipe using the special fastening band.Secure the water supply pipe to the hetaer to the thermostat using the special fastening band.Secure the water supply pipe to the heater using the retaining bands.Connect the electrical connector for the engine wiring coupling, the water temperature sensor and the earth on the engine.

	Name	Connector
-	Front/engine connection	D4A

	Name	Connector
-	Engine temperature sender unit	K36

	Name	Connector
-	Earth on engine	C40

Connect the lower radiator hose.Raise the car on a lift.Position the air filter casing in the special housing. - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R. - 7055B54 under-engine guard - r rLower the car with the lift. - 0010T20 coolant change - 0010T21 coolant check density and top up if necessaryConnect the flow meter electrical connector.

	Name	Connector
-	Air flow meter	K41

- 1048A23 cold air intake - r r - 1056B15 throttle body intergral with mds - r r - 1056B82 injection/ignition system e.c.u. (one) - r + r - 1016A40 ignition coil cover on cylinder head- r+r - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r - 5530B56 BATTERY DRIP TRAY COVER - R.R.