2127C28 PIPE FROM CLUTCH ENGAGEMENT SOLENOID VALVE TO CLUTCH HYDRAULIC ACTUATOR - R.R. - Fiat - STILO - eLearn

3362779 - 2127C28 PIPE FROM CLUTCH ENGAGEMENT SOLENOID VALVE TO CLUTCH HYDRAULIC ACTUATOR - R.R.

) - 5530B56 BATTERY DRIP TRAY COVER - R.R.- 5530B10 battery - r+r - 5530B52 Battery DRIP TRAY/SUPPORT - R.R. - 1048A10 air cleaner filtering element - replaceTemporarily refit the battery and reconnect the negative and positive terminals.Turn the ignition ON.Carry out the Selespeed hydraulic circuit depressurisation procedure using an Examiner tester. 1. Disconnect the electrical connection on the hydraulic selection system pump.

	Name	Connector
1	"Selespeed gearbox electric pump"	N47

Disconnect the negative and positive terminals and remove the battery.1. Disconnect the connector on the semi-rigid fluid supply pipe from the actuation unit.2. Raise the clip (2a) and disconnect the clutch actuator pipe (2b).3. Remove the pressurised fluid supply pipe from the solenoid to the clutch actuator.

Refitting ( Removing

) Fit the pressurised fluid supply pipe from the solenoid to the clutch actuator.Tighten the connector on the hydraulic unit and fully engage the pipe on the clutch actuator connector.Connect the electrical connection on the hydraulic selection system pump.

	Name	Connector
-	"Selespeed gearbox electric pump"	N47

- 1048A10 air cleaner filtering element - replace - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r - 0010T47 hydraulic system fluid for gearbox with hydraulic selection check level and top up if necessary- 0010T46 hydraulic system fluid for gearbox with hydraulic selection change - 5530B56 BATTERY DRIP TRAY COVER - R.R.