3363093 - 5530A14 ALTERNATOR - R+R FOR VERSIONS WITH AIR CONDITIONOMG
 Removing
		(
		Refitting
Removing
		(
		Refitting )
	    Op. 5530B56 BATTERY DRIP TRAY COVER - R.R.Disconnect the negative battery terminal.     1016A40 COPERCHIO BOBINE accensione su testa cilindri - S.R.Op. 5040A14 AIR CONDITIONING REFRIGERANT CIRCUIT - CHECK FOR LEAKS AND ELIMINATE IF NECESSARY BY TIGHTENING CONNECTORSPosition the vehicle on a lift.    Op. 4450B04 RIGHT FRONT WHEEL - R.R    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     7055B42 PASSARUOTA supplementare ANTERIORE (uno), sx o dx - S.R.(right side)     1092D10 CINGHIA comando compressore condizionatore aria - S.R.     1092B68 CINGHIA da compressore condizionatore a comando alternatore - S.R.Release the wiring for the alternator from the retaining bands.Raise the vehicle on the lift.1. Disconnect the electrical connections (1a) from the alternator undoing the fixing nuts (1b).
		)
	    Op. 5530B56 BATTERY DRIP TRAY COVER - R.R.Disconnect the negative battery terminal.     1016A40 COPERCHIO BOBINE accensione su testa cilindri - S.R.Op. 5040A14 AIR CONDITIONING REFRIGERANT CIRCUIT - CHECK FOR LEAKS AND ELIMINATE IF NECESSARY BY TIGHTENING CONNECTORSPosition the vehicle on a lift.    Op. 4450B04 RIGHT FRONT WHEEL - R.R    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     7055B42 PASSARUOTA supplementare ANTERIORE (uno), sx o dx - S.R.(right side)     1092D10 CINGHIA comando compressore condizionatore aria - S.R.     1092B68 CINGHIA da compressore condizionatore a comando alternatore - S.R.Release the wiring for the alternator from the retaining bands.Raise the vehicle on the lift.1. Disconnect the electrical connections (1a) from the alternator undoing the fixing nuts (1b).| Description | Connector | |
|---|---|---|
| 1 | Alternator | A10 | 



 Refitting
		(
		Removing
Refitting
		(
		Removing )
	Position the alternator in the special housing.Screw in the lower bolt securing the alternator without tightening it.1. Position the alternator wiring as illustrated in the diagram below so that it is not in contact with the catalytic pre-converter.
		)
	Position the alternator in the special housing.Screw in the lower bolt securing the alternator without tightening it.1. Position the alternator wiring as illustrated in the diagram below so that it is not in contact with the catalytic pre-converter.
| Fastening | Component | Ø | Value(daNm) | |
|---|---|---|---|---|
| - | Bolt | ALTERNATOR ASSEMBLY | M12 | 8 | 
| Fastening | Component | Ø | Value(daNm) | |
|---|---|---|---|---|
| - | Bolt | ALTERNATOR ASSEMBLY | M12 | 8 | 
| Description | Connector | |
|---|---|---|
| - | Alternator | A10 |