3360169 - A25 ALARM VOLUMETRIC SURVEILLANCE NOT WORKING

When the alarm is activated using the remote control unit, the system activates properly but does not intervene by means of the volumemetric sensors

The volumetric alarm control unit is supplied with a modular front courtesy light and includes modular sensors and an antitilt sensor.

		Results of the tests
1	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the Examiner to the body computer node and check that the alarm system configuration has been correctly programmed while in parameter mode.	Continue to Step 2	Volumetric alarm control unit absent.	Check car compliance
2	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check for errors in the volumetric alarm control unit.	Continue to Step 4	Volumetric alarm control unit error	Continue to Step 3
			A-Bus serial line not working.	Restore A-Bus serial line continuity/insulation See   E7015  ALARM
3	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Keep the Examiner connected and check for errors in the volumetric alarm control unit.	Continue to Step 4	Malfunction in the volumetric alarm control unit.	Change the volumetric alarm control unit.
4	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Change the body computer node Op. 5505A32Search for the fault starting from another symptom'