| | Results of the tests |
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect
the Examiner tester and check that door and boot lid status (open/closed)
is correctly received while in parameter mode. | Continue to Step 4 | Error in receiving door
and boot lid status (open/closed). | Continue to Step 2 |
| 2 | CHECKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
|---|
| Check
continuity/insulation of the connection between the body computer
node and door/s and boot lid. | Continue to Step 3 | Electrical connection damaged. | Restore continuity/insulation
of the damaged electrical connection. See E7015 ALARM |
| 3 | CHECKING ELECTRICAL COMPONENT
OPERATION | All
OK | Problems
met | Operation |
|---|
| Disconnect
the connector on the computer body node side and check for a door
open/closed and boot open/closed signal. See E7015 ALARM | Continue to Step 4 | Status indication switch
not working. | Change the damaged switch if a front door is affected. Op. 7005N21 |
| Status indication switch not working. | Change the damaged switch if a rear door is affected. Op. 7010N21 |
| Status indication switch not working. | Change the damaged switch if the boot lid is affected. Op. 7025B38 |
| 4 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | Change the body computer
node Op. 5505A32Search for the fault starting
from another symptom' |
