| | Results of the tests |
| 0 | PRELIMINARY CHECK | All OK | Problems met | Operation |
|---|
| Approach
the car, press the switch on the exterior handle of another door
and check the passive entry system works correctly. | Continue to Step 1 | The fault persists | Continue as instructed in
the diagnostic table See table P40 AUTOCLOSE NOT WORKING |
| 1 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Connect
an Examiner and check that there are no errors in the defective
door aerial on the passive entry node. | Continue to Step 3 | Door aerial defective | Continue to Step 2 |
| 2 | CHECKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
|---|
| Check
continuity/insulation of the electrical connection between the door
aerial and passive entry node. See E7018 PASSIVE ENTRY | Continue to Step 7 | Electrical connection broken
or not insulated | Restore electrical connection continuity/insulation See E7018 PASSIVE ENTRY |
| 3 | CHECKING WITH DIAGNOSTIC EQUIPMENT | All OK | Problems met | Operation |
|---|
| Keep
the Examiner connected and check door exterior handle switch status
has been correctly downloaded while body computer node is in parameter
mode. | Continue to Step 8 | Door exterior handle switch status
signal missing | Continue to Step 4 |
| 4 | CHECKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
|---|
| Check
continuity/insulation of the electrical connection between the door
exterior handle and passive entry node See E7018 PASSIVE ENTRY | Continue to Step 5 | Electrical connection broken
or not insulated | Restore electrical connection continuity/insulation See E7018 PASSIVE ENTRY |
| 5 | CHECKING ELECTRICAL CIRCUIT | All OK | Problems met | Operation |
|---|
| Check
continuity/insulation of the electrical connection between the exterior
handle and the relevant door node See E7018 PASSIVE ENTRY | Continue to Step 6 | Electrical connection broken
or not insulated | Restore electrical connection continuity/insulation
See E7018 PASSIVE ENTRY |
| 6 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | The fault persists | If front door, change the
exterior handle of the defective door Op. 7005C11 |
| The fault persists | If rear door, change the exterior handle of the defective
door Op. 7010C11 |
| 7 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | The fault persists | If front door, change the
defective door aerial Op. 5580E72 |
| The fault persists | If rear door, change the defective door aerial Op. 5580E74 |
| 8 | CHECKING CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | | The fault persists | Change the passive entry
node Op. 5580E70 Search for the fault starting
from another symptom' |