3360351 - Z50 MIXTURE STRENGTH ERROR

The diagnostic equipment signals the following error: Mixture strength

		Results of the tests
0	PRELIMINARY CHECKS	All OK	Problems met	Operation
1.6 16v 2.4 20v	Connect the tester (Examiner or Examiner Plus) and transcribe the errors and environmental parametersCheck for the 'Mixture strength' error only	End of diagnosis	'Upstream lambda probe' error present	See table   Z56
			'Upstream lambda probe' error present	Continue to Step 1
			'Upstream lambda probe' error present	Identify and eliminate the cause of the problem
1.2 16v 1.8 16v	Connect the tester (Examiner or Examiner Plus) and transcribe the errors and environmental parametersCheck for the 'Mixture strength' error only	End of diagnosis	'Upstream lambda probe' error present	See table   Z56
			Only the 'Mixture strength', 'Misfire', 'Catalyzer' and/or 'Downstream Lambda signal' errors are present	Continue to Step 2
			Other errors present	Identify and eliminate the cause of the problem
1	CHECKING SIGNAL PLAUSIBILITY	All OK	Problems met	Operation
1.6 16v	Check the plausibility of the MAP sensor signal.	Continue to Step 2	The signal is not plausible	Replace the sensor Op. 1056B44
2.4 20v	Checking the plausibility of the flow meter signal.	Continue to Step 2	The signal is not plausible	Replace the flowmeter Op. 1056B12
2	ERROR DETAIL CHECK	All OK	Problems met	Operation
1.2 16v	Check the detail of the 'Mixture strength' error	End of diagnosis	The detail is 'Above the upper limit'	See table   Z52
			The detail is 'Above the upper limit'	See table   Z51
1.6 16v	Check the detail of the 'Mixture strength' error	End of diagnosis	The detail is 'Rich system'	See table   Z51
			The detail is 'Idle too rich'	See table   Z51
			The detail is 'Lean system'	See table   Z52
			The detail is 'Idle too lean'	See table   Z52
1.8 16v	Check the detail of the 'Mixture strength' error	End of diagnosis	The detail is 'Above the upper limit'	See table   Z51
			The detail is 'Below lower limit'	See table   Z52
2.4 20v	Check the detail of the 'Mixture strength' error	End of diagnosis	The detail is 'Above the upper limit'	See table   Z52
			The detail is 'Air leaks downstream of flow meter'	See table   Z52
			The detail is 'Below lower limit'	See table   Z51