3362420 - 1028H20 piston with connecting rod - r r

Removing ( Refitting ) Place the car on a ramp. - 1048A10  air cleaner filtering element - replace - 1072C44  exhaust manifold heat shield on bulkhead - r+r - 1072C16  exhaust manifold with catalytic converter - r r - 1008B10  power unit front mount (timing side) flexible block - replace - 1008A46  cam shaft left rigid mount - r r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1032D12  timing system protective cover(s) - r + r - 1092B60  alternator drive belt - r + r - 1092A10  Crankshaft services PULLEY - R.R. - 1032B10  toothed timing belt - r + r for timing adjustment or replacement - 1016B10  single cylinder head extension - change gasket - 1016C10  cylinder head - r + r and replace gasket - 1020A30  engine oil drain plug - replace - 1020A20  crank case oil sump - r + r clean seals for sealant application - 1084B28  engine oil intake pump - r + r with crankcase sump removed1. Undo the bolts fixing the connecting rod cap.
Lower the lift.Remove the piston complete with connecting rod. Refitting ( Removing ) 1. Use the tool (1a) and fit the piston (1b) in the cylinder liner/bore.

NameCountry
1aFitting tool1.860.700.000
Make sure that the arrow, stamped on the piston crown, is facing the timing side and that the number, stamped on the big end, corresponds to the one of the connecting rod cap.
Position the connecting rod caps and secure them tightening the bolts to the recommended torque.

FasteningComponentØValue(daNm)
-BoltBIG END BEARING CAPSM84.1
 - 1084B28  engine oil intake pump - r + r with crankcase sump removed - 1020A20  crank case oil sump - r + r clean seals for sealant application - 1020A30  engine oil drain plug - replace - 1016C10  cylinder head - r + r and replace gasket - 1016B10  single cylinder head extension - change gasket - 1032B10  toothed timing belt - r + r for timing adjustment or replacement - 1092A10  Crankshaft services PULLEY - R.R. - 1092B60  alternator drive belt - r + r - 1092B64  alternator drive belt - adjust tension - 1032D12  timing system protective cover(s) - r + r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1008A46  cam shaft left rigid mount - r r - 1008B10  power unit front mount (timing side) flexible block - replace - 1072C16  exhaust manifold with catalytic converter - r r - 1072C44  exhaust manifold heat shield on bulkhead - r+r - 1048A10  air cleaner filtering element - replace - 0010T10  change engine oil - 0010T20  coolant changeRemove the vehicle from the ramp.