1020D16 FRONT CRANKSHAFT OIL SEAL COVER - R+R AND REPLACE GASKETS FOR VERSIONS WITH AIRCONDITIONER - Fiat - STILO - eLearn - 4CarData

3362408 - 1020D16 front crankshaft oil seal cover - r+r and replace gaskets for versions with airconditioner

Removing ( Refitting

) Place the car on a ramp. - 1048A10 air cleaner filtering element - replace - 1056B60 single fuel manifold pipe, with injectors - r + r - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1092B60 alternator drive belt - r + r - 1092A12 crankshaft pulley - r+r for versions with air conditioner - 1032D12 timing system protective cover(s) - r + r - 1008B10 power unit front mount (timing side) flexible block - replace - 1008A46 cam shaft left rigid mount - r r - 1032B10 toothed timing belt - r + r for timing adjustment or replacement - 1088C14 water pump - r + r with drive belt removed - 1072C44 exhaust manifold heat shield on bulkhead - r+r - 1072C16 exhaust manifold with catalytic converter - r r - 1032B44 toothed drive pulley - r + r with timing belt removed - 1020A30 engine oil drain plug - replace - 1084B30 engine oil filter r r - 1020A20 crank case oil sump - r + r clean seals for sealant application - 1084B28 engine oil intake pump - r + r with crankcase sump removed1. Undo the fixing bolts (1a) and remove the rpm sensor (1b)2. Disconnect the electrical connection for the engine oil pressure switch.

	Name	Connector
2	Engine oil pressure sensor (switch)	K30

1. Undo bolts (1a) and remove oil pump (1b).

Refitting ( Removing

) Fit oil pump and tighten securing bolts.Connect the electrical connection for the engine oil pressure switch.

	Name	Connector
-	Engine oil pressure sensor (switch)	K30

Secure rpm sensor using bolts - 1084B28 engine oil intake pump - r + r with crankcase sump removed - 1020A20 crank case oil sump - r + r clean seals for sealant application - 1084B30 engine oil filter r r - 1020A30 engine oil drain plug - replace - 1032B44 toothed drive pulley - r + r with timing belt removed - 1072C16 exhaust manifold with catalytic converter - r r - 1072C44 exhaust manifold heat shield on bulkhead - r+r - 1088C14 water pump - r + r with drive belt removed - 1008A46 cam shaft left rigid mount - r r - 1008B10 power unit front mount (timing side) flexible block - replace - 1032D12 timing system protective cover(s) - r + r - 1092A12 crankshaft pulley - r+r for versions with air conditioner - 1092B60 alternator drive belt - r + r - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1056B60 single fuel manifold pipe, with injectors - r + r - 1048A10 air cleaner filtering element - replace- 1088A10 Engine COOLANT - Check density' and top up level, if necessary - 0010T12 engine oil and filter replace - 0010T20 coolant changeRemove the vehicle from the ramp.