3362408 - 1020D16 front crankshaft oil seal cover - r+r and replace gaskets for versions with airconditioner

Removing ( Refitting ) Place the car on a ramp. - 1048A10  air cleaner filtering element - replace - 1056B60  single fuel manifold pipe, with injectors - r + r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1092B60  alternator drive belt - r + r - 1092A12  crankshaft pulley - r+r for versions with air conditioner - 1032D12  timing system protective cover(s) - r + r - 1008B10  power unit front mount (timing side) flexible block - replace - 1008A46  cam shaft left rigid mount - r r - 1032B10  toothed timing belt - r + r for timing adjustment or replacement - 1088C14  water pump - r + r with drive belt removed - 1072C44  exhaust manifold heat shield on bulkhead - r+r - 1072C16  exhaust manifold with catalytic converter - r r - 1032B44  toothed drive pulley - r + r with timing belt removed - 1020A30  engine oil drain plug - replace - 1084B30  engine oil filter r r - 1020A20  crank case oil sump - r + r clean seals for sealant application - 1084B28  engine oil intake pump - r + r with crankcase sump removed1. Undo the fixing bolts (1a) and remove the rpm sensor (1b)2. Disconnect the electrical connection for the engine oil pressure switch.

NameConnector
2Engine oil pressure sensor (switch)  K30 
1. Undo bolts (1a) and remove oil pump (1b).
Refitting ( Removing ) Fit oil pump and tighten securing bolts.Connect the electrical connection for the engine oil pressure switch.

NameConnector
-Engine oil pressure sensor (switch)  K30 
Secure rpm sensor using bolts - 1084B28  engine oil intake pump - r + r with crankcase sump removed - 1020A20  crank case oil sump - r + r clean seals for sealant application - 1084B30  engine oil filter r r - 1020A30  engine oil drain plug - replace - 1032B44  toothed drive pulley - r + r with timing belt removed - 1072C16  exhaust manifold with catalytic converter - r r - 1072C44  exhaust manifold heat shield on bulkhead - r+r - 1088C14  water pump - r + r with drive belt removed - 1008A46  cam shaft left rigid mount - r r - 1008B10  power unit front mount (timing side) flexible block - replace - 1032D12  timing system protective cover(s) - r + r - 1092A12  crankshaft pulley - r+r for versions with air conditioner - 1092B60  alternator drive belt - r + r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. - 1056B60  single fuel manifold pipe, with injectors - r + r - 1048A10  air cleaner filtering element - replace- 1088A10 Engine COOLANT - Check density' and top up level, if necessary  - 0010T12  engine oil and filter replace - 0010T20  coolant changeRemove the vehicle from the ramp.