3362811 - 2710A54 l/h or r/h wheel end constant velocity joint (one) - r + r with drive shaft removed - including boot replacement
Removing
(
Refitting
)
Place the drive shaft in a vice.1. Remove the clip and push back the gaiter.2. Remove the constant velocity joint from the drive shaft.3. Clean the grease off the inside of the bearing housing, and,
using tools (3a) and (3b) while at the same time using pliers on
the retaining ring inside the joint, remove the ring (3c) fixing
the constant velocity joint bearing. 4. Then remove the protective gaiter (4a), removing the clip (4b). | Name | Country |
|---|---|---|
| 3a | Counter weight | 1.847.017.001 |
| Name | Country |
|---|---|---|
| 3b | Adaptor | 1.860.889.000 |
Refitting
(
Removing
)
Check that the drive shaft is not deformed
or out of true in the area where the joint fits, and that the area
in contact with the seal is not worn.Fit the new protective gaiter on the drive
shaft.Fit the gearing on the drive shaft.Fill the protective gaiter and bearing
with suitable grease. | Type | Component | Name | Qty. |
|---|---|---|---|---|
| - | Grease (g) | DRIVESHAFT | TUTELA STAR 325 | 85 |