1072B10 INLET MANIFOLD - R + R AND REPLACE SEAL - Fiat - STILO - eLearn

3362481 - 1072B10 INLET MANIFOLD - R + R AND REPLACE SEAL

) Op. 5530B56 BATTERY DRIP TRAY COVER - R.R..Disconnect the battery negative terminal. Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R + R 1048A32 sleeve from air cleaner to intake manifold - r + r Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R 1056B15 throttle body intergral with mds - r r Op. 1080E28 ENABLEMENT SOLENOID FOR FLOW OF FUEL VAPOUR TO INLET - R+RPosition a suitable container to collect the coolant.1. Disconnect the electrical connection from the engine coolant temperature sensor.

	Name	Connector
1	Engine temperature sender unit	K36

2. Open the band (2a) and disconnect the engine coolant return pipe from the heater (2b).

Plug the engine coolant return pipe from the heater.

1. Disconnect the anti-evaporation pipe.

1. Remove the brake servo vacuum pipe to one-way valve (1a) and release it from the retaining band (1b).

Release the electrical wiring from the retaining clip housed behind the inlet manifold.1. Disconnect the electric connection from the third cylinder fuel injector.

	Name	Connector
1	Injector	N70

2. Undo the fixing bolt (2a) and the nuts (2b) and remove the inlet manifold (2c).

Refitting ( Removing

) Position the inlet manifold and tighten the nuts fixing it to the cylinder head.

	Fastening	Component	Ø	Value(daNm)
-	Nut	INLET MANIFOLD	M7	1.5

Tighten the fixing bolt on the camshaft housing.Secure the electrical wiring to the retaining springs housed behind the inlet manifold.Fit the brake servo vacuum pipe and secure to the retaining clip.Connect the anti-evaporation pipe.Connect the coolant supply pipe to the heater and secure it using the retaining band.Disconnect the electrical connection from the engine coolant temperature sensor.

	Name	Connector
-	Engine temperature sender unit	K36

Op. 1080E28 ENABLEMENT SOLENOID FOR FLOW OF FUEL VAPOUR TO INLET - R+R 1056B15 throttle body intergral with mds - r r Op. 1056B82 INJECTION/IGNITION SYSTEM E.C.U. (ONE) - R + R 1048A32 sleeve from air cleaner to intake manifold - r + r Op. 1056B60 SINGLE FUEL MANIFOLD PIPE, WITH INJECTORS - R + R Op. 1048A10 AIR FILTER ASSEMBLY - R.R. Op. 0010T21 ENGINE COOLANT - CHECK DENSITY AND CHANGE, IF NECESSARYConnect the battery negative terminal. Op. 5530B56 BATTERY DRIP TRAY COVER - R.R..