3360176 - B02 STARTER MOTOR NOT WORKING

The starter motor does not work when the igntiion is turned ON.

		Results of the tests
0	CHECKING WITH DIAGNOSTIC EQUIPMENT	All OK	Problems met	Operation
	Connect the diagnostic equipment (Examiner) and check battery charge	Continue to Step 2	battery charge insufficient	Recharge the battery Op. 5530B10
			battery charge insufficient	Replace the battery Op. 5530B10
1	CHECKING ELECTRICAL CIRCUIT	All OK	Problems met	Operation
	Check continuity/insulation of electrical connection between starter motor and battery See   E5010  STARTING AND RECHARING	Continue to Step 2	Electrical conection broken or not insulated.	Restore continuity/insulation of electrical connection See   E5010  STARTING AND RECHARING
2	CHECKING ELECTRICAL CIRCUIT	All OK	Problems met	Operation
	Check continuity/insulation of ignition barrel and starter motor connection. See   E5010  STARTING AND RECHARING	Continue to Step 3	Electrical connection broken or not insulated.	Continue to Step 4
	Check condition and correct operation of starter motor.	Continue to Step 3	Starter motor faulty.	Overhaul the starter motor. ( Op. 5520B14)
			Unrepairable starter motor fault	Replace starter motor ( Op.   5520B12  )
3	CHECKING IGNITION BARREL	All OK	Problems met	Operation
	Check that the ignition barrel is working properly.	Continue to Step 7	Ignition barrel damaged.	Change the ignition barrel Op. 5520A10.
4	CHECKING ELECTRICAL CIRCUIT	All OK	Problems met	Operation
	Check continuity/insulation of electrical connection between ignition block and engine bay control unit See   E5010  STARTING AND RECHARING	Continue to Step 5	Electrical connection broken or not insulated.	Restore continuity/insulation of electrical connection See   E5010  STARTING AND RECHARING
5	CHECKING ELECTRICAL CIRCUIT	All OK	Problems met	Operation
	Check continuity/insulation of electrical connection between engine bay control unit and starter motor See   E5010  STARTING AND RECHARING	Continue to Step 6	Electrical connection broken or not insulated.	Restore continuity/insulation of electrical connection See   E5010  STARTING AND RECHARING
6	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Change the engine bay control unit Op. 5505A13.Search for the fault starting from another symptom'
7	CHECKING CORRECT OPERATION	All OK	Problems met	Operation
	Check that the fault is no longer present	End of diagnosis	Fault persists	Change theh engine bay control unit. Op.   5520B10  Search for the fault starting from another symptom'