1080E62 PIPE FROM FUEL VAPOUR SEPARATOR TO SOLENOID - R R - Fiat - STILO - eLearn

3362501 - 1080E62 pipe from fuel vapour separator to solenoid - r r

) - 1016A10 sound-proofing cover - r + r1. Disconnect the connector on the air inlet chamber, for the fuel vapour recovery pipe.2. Disconnect the electrical connection from the solenoid.

	Name	Connector
2	Fuel vapour recovery solenoid	L10

Release the pipe from the clips securing it to the bulkhead.

Raise the car.1. Undo the fixing bolts (1a) and remove the right side guard (1b) from the fuel tank.

1. Disconnect the quick-fit connector on the pipe between the solenoid and active charcoal filter.

1. Undo the fixing bolts (1a) and remove the fuel and anti-evaporation pipe guard (1b).

1. Release the anti-evaporation pipe (1a) from the clips (1b) located under the body.

1. From the top of the engine compartment, remove the anti-evaporation pipe complete with vapour recovery solenoid.

Refitting ( Removing

) Working from the bottom of the car, fit the pipe complete with solenoid, partially raise the ramp and fit the anti-evaporation pipe back in its housing.Secure the pipe to the retaining clips located under the body.Connect the anti-evaporation pipe to the quick-fit connector with the rear section connecting to the active charcoal filter.Fit the pipe rear guard and tighten the fixing bolts.Fit the fuel tank right side guard and tighten the fixing bolts.Lower the vehicle.Connect the anti-evaporation pipe connector to the inlet chamber.Disconnect the electrical connection from the solenoid.

	Name	Connector
-	Fuel vapour recovery solenoid	L10

Secure the pipe to the bulkhead. - 1016A10 sound-proofing cover - r + r