3340B55 CENTRAL BRAKE PIPE TO LH - R R - Fiat - STILO - eLearn

3362882 - 3340B55 central brake pipe to lh - r r

) Place the car on a lift. - 4450B02 left front wheel r r1. Disconnect the flexible pipe (1a) from the rigid pipe (1b) using the special tool, and release the retaining clip (1c).

	Name	Country
-	Box wrench for brake fittings	1.856.132.000

Refitting ( Removing

) Fit the rigid pipe from the hydraulic control unit to the front left brake.

Removing ( Refitting

) Place the car on a lift. - 4450B02 left front wheel r r - 7055B54 under-engine guard - r r - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R.Remove the protective cap from the bleed valve of one front brake caliperConnect the collection system (pipe and reservoir) to the bleed valve on the brake caliper. Operate the brake pedal until the brake-clutch fluid reservoir is empty. 1. Disconnect the flexible pipe (1a) from the rigid pipe (1b) and release the retaining clip (1c).

- 1016A10 sound-proofing cover - r + r- 5530B10 battery - r+r - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.Release the rigid pipe from the clips fixing it to the bodywork.1. Undo the connector and disconnect the rigid pipe on the electro-hydraulic control unit.

Seal the oil pipe threaded seats.

Remove the rigid pipe from hydraulic control unit to front left brake.

1. Undo the bolts (1a) fixing the pump master cylinder (1b) and move it aside as far as possible.Remove the rigid pipe from hydraulic control unit to front left brake.

Refitting ( Removing

) Fit the rigid pipe from the hydraulic control unit to the left front brake.Tighten the nuts fixing the pump master cylinder tightening them to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	CLUTCH FLUID MASTER CYLINDER	M8	2.2

Fit the rigid pipe from the hydraulic control unit to the left front brake.

The protection for the threaded seats should only be removed when fitting the brake pipes to prevent possible impurities from being introduced into the control unit.

Tighten the connector and connect the rigid pipe to the electro-hydraulic control unit.

	Fastening	Component	Ø	Value(daNm)
-	Male connector	ABS CONTROL UNIT RIGID FRONT BRAKE PIPES../	M10	16

Secure the rigid pipe to the fastening clips on the bodyshell. - 5530B52 Battery DRIP TRAY/SUPPORT - R.R.- 5530B10 battery - r+r - 1016A10 sound-proofing cover - r + rConnect the flexible pipe to the rigid pipe and secure the retaining clip. - 7055B42 Additional FRONT WHEEL ARCH (one), left or right - R.R. - 7055B54 under-engine guard - r r - 4450B02 left front wheel r rRemove the vehicle from the lift. - 0010T64 brake and or clutch fluid check level and top up as necessary - 0010T65 hydraulic brake system bleed air