3362944 - 4450B40 rear wheel geometry - check using optical equipment
Place the car on a control surface, with sliding plates under all the wheels.Place the car in standard load conditions (full vehicle weight complete with spare wheel, tools, accessories and full tank of fuel).Check that the tyre pressures are correct.Under these conditions, check the characteristic angles of the rear suspension indicated below.CHECK ON TOE-IN | The rear suspension consists of a rigid axle and therefore the toe in cannot be adjusted. If the value measured is not within the recommended limits, check the drive axle and the bodyshell. |
| The rear wheel camber cannot be adjusted. If the value measured is not within the recommended limits, check the drive axle and the bodyshell. |