3362932 - 4410D13 front suspension beam - r r

Removing ( Refitting ) Place the car on a ramp. - 5530B56  BATTERY DRIP TRAY COVER - R.R.Disconnect the battery negative terminal. - 4450B12  front or rear wheels (two) - r+r - 7055B54  under-engine guard - r r - 7055B42  Additional FRONT WHEEL ARCH (one), left or right - R.R. 1. Undo the fixing nuts (1a) and disconnect the exhaust pipe (1b) from the manifold (1c).
Refitting ( Removing ) Position the crossmember on a hydraulic jack and raise it until the crossmember is fully against the bodyshell.Tighten to torque the bolts securing the crossmember brackets to the bodyshell.

FasteningComponentØValue(daNm)
--ENGINE OR ROD ANCHORAGE BEAMM12 x 1.511.
Tighten to torque the bolts securing the crossmember to the bodyshell.

FasteningComponentØValue(daNm)
--ENGINE OR ROD ANCHORAGE BEAMM14 x 1.515
Tighten to torque the bolts securing the steering box to the crossmember.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM12 x 1.258,5
Tighten to torque the bolts securing the anti-roll bar.

FasteningComponentØValue(daNm)
-BoltENGINE OR ROD ANCHORAGE BEAMM82,5
 - 4410B40  lower wishbone (with balljoint) of left or right front suspension (one) - r+r -check wheel geometry separately - 1008C32  GEARBOX LOWER REACTION ROD ' -R.R. Position the exhaust pipe on the manifold and tighten the fixing nuts to the recommended torque.

FasteningComponentØValue(daNm)
-NutEXHAUST PIPE TO ENGINEM82.5