3363561 - 1028H14 PISTON CONNECTING ROD SET - R.R. WITH ENGINE AND CYLINDER HEAD(S) REMOVED

Removing ( Refitting )     Op. 1020A24 CRANKCASE OIL SUMP - R.R CLEAN SURFACES FOR SEALANT APPLICATION WITH ENGINE OR INTERFERING COMPONENTS REMOVED.1. Undo the retaining bolts.2. Remove the engine oil pump (2a) complete with oil suction device (2b).Keep the oil pump gasket.3. Undo the fixing bolt (3a) and remove the section inside the crankcase (3b) for the engine oil dipstick.
1. Use service bolts (1a) to fit the tool (1b) used to rotate the crankshaft.
DescriptionCode
1bFlange1.860.815.000
1. Undo the fixing bolts (1a) and remove the connecting rod cap (1b).2. Remove the lower connecting rod half-bearing.3. Remove the connecting rod-piston assembly.4. Remove the upper connecting rod half-bearing.
Refitting ( Removing ) Turn the crankshaft using the tool fitted previously.1. The connecting rod-piston assemblies are fitted with the engine rotation arrow stamped on the piston crown pointing towards the inlet side.2. Check that the stamp on the cylinder bore/liner to which the connecting rod belongs is on the exhaust side.
1. Fit the connecting rod-piston assembly (1a) with half-bearing using the tool (1b) to compress the piston rings and then fit the piston into the bore/liner.
Fit the crankpin caps.Tighten the nuts fixing the connecting rod caps to torque.
FasteningComponentØ  Value(daNm)
-NutCONNECTING ROD CAPSM94.8 - 5.4
Remove the tool for rotating the crankshaft.
DescriptionCode
-Flange1.860.815.000
Fit the crankcase internal section for the engine oil dipstick.Position a new oil pump gasket.Fit the oil pump tightening the fixing bolts to torque.
FasteningComponentØ  Value(daNm)
-BoltENGINE OIL PUMPM82.3 ÷ 2.8
    Op. 1020A24 CRANKCASE OIL SUMP - R.R CLEAN SURFACES FOR SEALANT APPLICATION WITH ENGINE OR INTERFERING COMPONENTS REMOVED.