194000215 - 0010T12 ENGINE OIL AND FILTER - REPLACE

Engine oil is harmful to skin: keep contact with skin to a minimum and if there is contact wash with soap and water.

- Position the vehicle on a lift.1. Remove the sound insulation cover fastened to the engine by three pins.2. Remove the filler cap with the engine hot.3. Release the engine oil dipstick. 1. Remove the engine oil filter (1a) using a suitable tool (1b).2. Remove the seal.3. Extract the engine oil filter cartridge. 1. Undo the drain plug in the crankcase sump and leave the oil to drain into a suitable container.

Be very careful when removing the drain plug, the oil could be very hot.

Do not let the oil disperse into the environment as indiscriminate dispersion of this product causes pollution.

- Clean the drain plug and tighten it complete with a new gasket to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Engine oil drain plug	-	M12 x 1.75	(oil sump side) 2.5	2.2

- Place a new engine oil filter cartridge in its housing.- Place the engine oil filter cover complete with a new gasket in its housing and tighten it to the recommended torque using the tool.

Component	Fastening	dia	Value (daNm)	Validity
Engine oil filter cover	-	-	2.5

- Refill the engine lubrication circuit with the recommended oil.

Component	Type	Description	Classification	Qty.	Validity
ENGINE LUBRICATION SYSTEM	Oil	SELENIA PERFORMER MULTIPOWER	SAE 5W-30 - FIAT 9.55535-G1 - ACEA A3/B3	5.0 litres	2.2

The table shows the quantity for periodic replacement.

- For the use of the vehicle in particularly severe climate conditions it is advisable to use the recommended oil for the engine lubrication circuit.

Component	Type	Description	Classification	Qty.	Validity
ENGINE LUBRICATION SYSTEM	Oil	SELENIA DIGITECH	SAE 0W-30	5.0 litres	2.2

The table shows the quantity for periodic replacement.

- Check that the engine oil level is correct using the dipstick.

The oil level is checked with the vehicle on a flat surface.

- Fit the filler cap, let the engine idle for about 2 minutes, switch off the engine and then wait for several minutes.- Check the oil level and make sure there are no leaks.- Place the sound insulation cover back in its housing- Remove the vehicle from the lift.