194000384 - 1084A42 ENGINE OIL PRESSURE WARNING LIGHT SWITCH - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 5520B10 STARTER MOTOR - R+R1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Description	Connector
1	Insufficient engine oil pressure sensor (switch)	See K030 INSUFFICIENT ENGINE OIL PRESSURE SENSOR

2. Undo and remove the engine oil pressure warning light switch.

Collect the engine oil that comes out in a suitable container.

Refitting ( Removing ) - Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Switch for engine oil pressure warning light	-	M12 x 1.75	(engine crankcase side) 1.8	2.2

- Connect the electrical connection to the engine oil pressure warning light switch.    Op. 5520B10 STARTER MOTOR - R+R- Connect the negative battery terminal.- Remove the vehicle from the lift.