194000419 - 1092B93 WATER PUMP /BALANCING SHAFT DRIVE CHAIN TENSIONER PADS R R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 4450B04 RIGHT FRONT WHEEL - R.R    Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.    Op. 1032A12 TIMING SYSTEM DRIVE CHAIN - R.R1. Remove the timing drive pulley. 1. Unscrew the bolts (1a) and remove the water pump/balancer shaft drive chain hydraulic tensioner. 1. Undo the bolts (1a) and remove the chain tensioner pads (1b). Refitting ( Removing ) 1. Place the chain tensioner pads (1a) in their housings and secure them tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Water pump/balancing shafts drive chain pad(s)	Bolt	M6 x 1	(engine crankcase side) 1.0	2.2

1. Fit a suitable pin (diameter 1.5 mm) to secure the counterrotating shaft and water pump drive chain tensioner.

Press the tensioner piston and turn to the right to fit the tool.

2. Refit the water pump/balancer shaft drive chain hydraulic tensioner (2a) and secure by tightening bolts (2b) to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Water pump/balancing shafts drive chain hydraulic tensioner	Bolt	M6 x 1	(engine crankcase side) 1.0	2.2

- Remove the pin locking the counter-rotating shaft and water pump drive chain tensioner. - Place the timing drive chain pulley in its housing.

Take care over the fitting position.

    Op. 1032A12 TIMING SYSTEM DRIVE CHAIN - R.R    Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.    Op. 4450B04 RIGHT FRONT WHEEL - R.R- Connect the negative battery terminal.    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY- Remove the vehicle from the lift.