194000706 - 5520B10 STARTER MOTOR - R+R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

1. Disconnect the electrical connection from the engine oil level sensor.

	Description	Connector
1	Engine oil level sensor	See K032 ENGINE OIL LEVEL SENSOR

2. Disconnect the electrical connection from the rpm sensor.

	Description	Connector
2	Rpm sensor	See K046 RPM SENSOR

- Open the access cover for the electrical connection.3. Undo the nuts (3a) and disconnect the electrical connections (3b) from the starter motor.

	Description	Connector
3b	Starter motor	See A020 STARTER MOTOR

4. Undo the bolts (4a) and remove the starter motor (4b). Refitting ( Removing ) 1. Place the starter motor (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Starter motor	Bolt	M10 x 1.5	(gearbox side) 3.5 - 4.5	2.2

2. Connect the electrical connections (2a) to the starter motor and secure them using the nuts (2b).- Close the access cover for the electrical connection.3. Connect the electrical connection to the rpm sensor.4. Connect the electrical connection to the engine oil level sensor. - Connect the negative battery terminal.- Remove the vehicle from the lift.