194000473 - 3310A60 FRONT BRAKE PADS - REPLACE

Removing ( Refitting )

The following procedure describes the removing-refitting of the left front brake pads, carry out the same operations for the right front brake pads.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 4450B02 LEFT FRONT WHEEL - R.R1. Disconnect the electrical connection for the brake pad wear sensor and release the wiring from the fastenings.

	Description	Connector
1	Left brake pad wear sensor (switch)	See K020 LEFT BRAKE PAD WEAR SENSOR (SWITCH)

There is no brake pad wear sensor on the right front caliper.

1. Remove the brake caliper spring. 1. Remove the plugs (1a) and undo the brake caliper fixing bolts (1b).2. Move the brake caliper complete with inner pad from its housing. 1. Remove the front brake pads. Refitting ( Removing ) 1. Push the brake caliper piston into its housing using a suitable tool.

The level of the brake fluid in the reservoir will increase; if necessary, draw off any excess fluid using a suitable tool.

2. Grease the brake caliper and bracket in the areas of the pad support surfaces. - Place the lfront brake pads in their housings.1. Place the brake caliper assembly in its housing.2. Tighten the bolts (2a) fixing the brake caliper to the recommended torque and fit the plugs (2b).

Component	Fastening	dia	Value (daNm)	Validity
Front brake calipers	Bolt	-	(bracket side) 2.5 - 3.0	1.82.21.9 JTD 8v

- Place the brake caliper spring in its housing.- Connect the electrical connection for the brake pad wear sensor and fasten the electrical wiring.    Op. 4450B02 LEFT FRONT WHEEL - R.R- Connect the negative battery terminal.- Remove the vehicle from the lift.