194002007 - J042 RIGHT DOOR MIRROR ELECTRICAL ADJUSTMENT NOT WORKING

When the control is operated the right external mirror does not move.

The mirror is adjusted by the Passenger Door Node according to information from the adjustment joysticks located on the driver''s door handle.

The joystick information (selection, controls) is sent from the Driver''s Door Node to the Passenger Door Node.

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic connect and check the following at the Driver''s Door Node:In errors ambient that there are no faults In parameters ambient the plausibility of the parameters for joystick (left/right/up/down).	Move on to Step 2	1. Presence of faults	1. Continue following the instructions for the diagnostic equipment.
			2. Mirror selector joystick parameters (left/right/up/down) not plausible.	2. Move on to Step 3
2	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Keeping the Examiner diagnostic equipment connected to the diagnostic connector, check the following at the Passenger Door NodeIn errors ambient that there are no faults. In active diagnosis ambient the operation of the mirror movement motors.	Move on to Step 3	1. Presence of faults	1. Continue following the instructions for the diagnostic equipment.
			2. Adjustment motors not working.	2. Move on to Step 4
3	MIRROR ADJUSTMENT JOYSTICK OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the control panel on the driver''s door, disconnect the connector and check the operation of the joystick.    Op. 7005M14 SWITCH UNIT ON DRIVER'S FRONT DOOR - R.R.    See Test 7005RA CHECK ON OPERATION OF DOOR MIRROS ADJUSTMENT/FOLDING	Move on to Step 7	Mirror control joystick faulty	Replace the external mirrors control joystick    Op. 7005M14 SWITCH UNIT ON DRIVER'S FRONT DOOR - R.R.
4	ELECTRICAL SYSTEM CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the right rear view mirror, disconnect the connector for the movement motors, remove the Passenger Door Node and check: the continuity between the connector and the Passenger Door Node; the presence of the joint supply positive.     Op. 7005R35 DOOR MIRROR REFLECTOR (ONE), LEFT OR RIGHT - R.R    See E3032 DOOR MIRROR ADJUSTMENT	Move on to Step 5	1. Electrical connection interrupted.	Move on to Step 5
			2. No positive supply.	Move on to Step 5
5	ELECTRICAL SYSTEM CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the door panel and check: the continuity between the Passenger Door Node and the mirror connector; the presence of the joint supply positive.     See E3032 DOOR MIRROR ADJUSTMENT	Move on to Step 6	1. Electrical connection interrupted.	1. Restore the electrical connection    See E3032 DOOR MIRROR ADJUSTMENT
			2. No positive supply.	2. Replace the Passenger Door Node    Op. 5505A46 CONTROL UNIT (DIGITAL NETWORK NODE) IN PASSENGER SIDE DOOR - R.R.
6	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present.	End of diagnosis	Fault persists.	Replace the rear view mirror.    Op. 7005R30 ELECTRICALLY CONTROLLED DOOR MIRROR (ONE) - R+R
7	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present.	End of diagnosis	Fault persists.	Replace the Driver''s Door Node    Op. 5505A42 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R.