194002086 - A035 TILT SENSOR ALARM NOT WORKING

The anti-tilt sensor is located in the courtesy light module and is connected to the Body Computer by means of the dialogue line known as the A-BUS. The tilt sensor is operated and controlled by the Body Computer Node via a series of encrypted messages and can be excluded by the customer using the special button. If there is a failure the Body Computer Node detects and memorizes the causes of the malfunction

		Results of the tests
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node in parameters ambient:. the presence of the tilt sensor in the errors ambient:. that there are no problems relating to the tilt sensor	Move on to Step 2	Tilt sensor excluded manually	Switch on tilt sensor
			Tilt sensor not present	Check the conformity of the vehicle
			Presence of faults	Proceed as instructed by the diagnostic tester
2	TILT MODULE POWER SUPPLY CHECK	All OK	Problems encountered	Operation
	Check that the anti-tilt module is correctly supplied	Move on to Step 3	Supply not correct	Restore correct power supply
3	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node. In active diagnosis:. the operation of the tilt module. the condition of the A-Bus serial line	Move on to Step 4	A-BUS serial line interruption	Restore the serial line    See E7015 ALARM
			Anti-tilt module defective	Replace the courtesy light module with built-in tilt sensor    Op. 7040E51 FRONT MODULAR COURTESY LIGHT ASSEMBLY - R R FOR VERSIONS WITH SUN-ROOF
4	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present	Fault persists	Body Computer defective	Replace Body Computer    Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.