K091 INSTRUMENT LIGHTS DIMMER NOT WORKING - Fiat - CROMA - eLearn

194002498 - K091 INSTRUMENT LIGHTS DIMMER NOT WORKING

With the ignition ON and the side lights on, the instrument panel lights up, but when the lighting controls are operated it remains on constantly

the side lights work properly

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner check, in the Instrument Panel Node ambient, that there are no errors and that the parameters are present.	Move on to Step 5	1. Impossible to connect with the Instrument Panel control unit	1. Move on to Step 2
		Move on to Step 5	2. Presence of errors	2. Continue following the instructions on the diagnostic instrument
2	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the electricity supply to the Instrument Panel Node is correct.	Move on to Step 3	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow).
3	CHECK ELECTRICAL CONNECTIONS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the wiring between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected. See E4010 INSTRUMENT PANEL	Move on to Step 4	Electrical connections not operational	Renew the damaged electrical connections
4	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Use an Examiner to check the possibility of connection to the Instrument Panel Node	Move on to Step 5	Impossible to connect with the Instrument Panel control unit	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
5	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	With the Examiner in Instrument Panel Node mode, check that the instrument panel light is correctly activated in Active Diagnosis.	Move on to Step 6	The panel lighting is not activated	Replace the Instrument Panel Op. 5560B10 CONTROL PANEL - R+R
6	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner check, in the Body Computer ambient, that there are no errors and that the lighting parameter varies	Move on to Step 7	1. Impossible to connect to the Body Computer control unit.	1. Move on to Step 7
			2. Presence of errors	2. Continue following the instructions on the diagnostic instrument
			3. The parameters do not change	3. Move on to Step 9
7	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the electricity supply to the Body Computer Node is correct.	Move on to Step 8	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow)
8	CONNECTIONS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the continuity of the wiring between the control panel and the Body Computer Node See E4010 INSTRUMENT PANELAlso check that the MODE +/- buttons are working properly	Move on to Step 9	1. Electrical connections not operational	1. Renew the damaged electrical connections
		Move on to Step 9	2. Buttons faulty	2. Replace the control panel Op. 7040A82 SWITCH UNIT ON LEFT SIDE OF DASHBOARD - R.R.
9	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Use an Examiner to check the possibility of connection to the Body Computer Node	Move on to Step 10	Impossible to connect to the Body Computer control unit.	Replace Body Computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.
10	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present	End of diagnosis