| CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK |
|---|
| 1 | Inser the key in the ignition and turn to STOPCheck that the key is released mechanically in the ignition.Check that the steering is released. | Restore B-Can continuity See E1050 CAN CONNECTION LINES |
| 2 | Connect the diagnostic tester to the TEG Reader node.Insert the key in the ignition and check that the system recognises the key by turning ON (transponder reading stage).The test can be considered over | Replace the key and store it in the Teg Reader node. See descriptions 5580E ANTI-THEFT DEVICEMove on to Step 3 |
| 3 | Connect the diagnostic instrument in Voltmeter mode with the positive terminal to Pin 3 and the negative earthed to Pin 4 of the ignition device See H003 IGNITION DEVICEThe direct voltage reading should be 12 Volt. | Restore the power supply See E5010 STARTING AND RECHARING |
| 4 | Fit the key in the ignition.Connect the diagnostic instrument in Voltmeter mode with the positive terminal connected to device Pin 12 and the negative earthed. The direct battery voltage reading should be less than 10.6 Volts. See H003 IGNITION DEVICE | Replace the ignition lock Op. 5520A10 IGNITION SWITCH ASSEMBLY - R+R |
| 5 | With the diagnostic instrument in Voltmeter mode, connect the positive probe to device Pin 6 and the negative to earth See H003 IGNITION DEVICETurn the key ON and check for a voltage of 12 Volts. | Replace the ignition lock Op. 5520A10 IGNITION SWITCH ASSEMBLY - R+R |
| 6 | With the diagnostic instrument in Voltmeter mode, connect the positive probe to device Pin 5 and the negative to earth See H003 IGNITION DEVICEPress the clutch pedal.Turn the key ON and check for a voltage of 12 Volts. | Replace the ignition lock Op. 5520A10 IGNITION SWITCH ASSEMBLY - R+R |
| 7 | With the diagnostic instrument in Voltmeter mode, connect the positive probe to device Pin 11 and the negative to earth See H003 IGNITION DEVICEPress the clutch pedal.Turn the key ON and check for a voltage of 12 Volts. | Replace the ignition lock Op. 5520A10 IGNITION SWITCH ASSEMBLY - R+R |