194002532 - 5040BC CLIMATE CONTROL COMPRESSOR LINEAR SENSOR ON/OFF CHECK (AUTOMATIC AIR CONDITIONING)

Disconnect the electrical connection for the linear sensor.    See K120 LINEAR SENSOR FOR FANSCheck that Pin 1 is earthed and Pin 2 is at +5V.Connect a linear potentiometer (end of scale 1 KOhm, previously positioned at around 500 ohm between the centre pin andone of the side ones) to the pins of the linear sensor electrical connector.Turn the ignition key to the ON position.Using a multimeter, check that the voltage between pins 1 and 3 is around 2.5V.Switch on the engine and switch on the air conditioning using the special switch located on the climate control system control unit.The climate control system should come on normally in these circumstances.Vary the resistance of the potentiometer, until the voltage reading on the multimeter between pins 1 and 3 is around 0V. In these conditions the air conditioning system should switch off because the engine management node receives low pressure information for the circuit.Alter the potentiometer resistance until the voltage reading on the multimeter between pins 1 and 3 is about 4.6 V.The air conditioning system should switch off in these conditions because the engine management node receives high circuit pressure information.