194001472 - E3050 FRONT ELECTRIC WINDOWS - DESCRIPTION (RIGHT HAND DRIVE)

The electric windows for the front doors are operated through the switches on the driver''s door (both windows) and the passenger side (passenger side only).The control units in the door control the operation of the driver''s and passenger side electric window motors which are operated both manually and automatically depending on the version.Automatic operation takes place as follows:- if the button is pressed is between 50 and 300 milliseconds, operation is manual. the glass goes up/down only with the key pressed;- f the key is pressed for longer than 300 milliseconds, operation is automatic: even if the button is released, the glass continues to move up/down until the end of travel position is reached or until the intervention of the anti-crush safety system (if fitted);- pressing the button again whilst the window is moving stops it in the position it is in;- if the button is pressed for less than 50 milliseconds, this is ignored (it is treated as an accidental knock).Each control unit in the door also manages the anti-pinch safety function: In other words, it acquires information on the possible presence of an obstacle as the window is closing (as the window rises, two resistive sensors in the window motor immediately stop the window and reverse its direction of travel if an obstacle is encountered during closure.The anti-pinch safety function is activated during both manual and automatic operation.If the controls units on the door reveal the presence of an obstacle in the reversal area as the window rises, they must:- stop the window rising and reverse the direction immediately within a total time of 30 ms.- reverse the travel of the window, which should reach a position corresponding to an opening of at least 200 mm from the upper edge or at least 50 mm higher than the initial starting position of the window.- ignore any type of further raise or lower command during the reversal period.If the door control units detect the presence of an obstacle in the "non reversal zone" they should only interrupt the upwards movement of the window.The correct operation of the anti-pinch sensor is controlled by the control unit check function: in the case of a failure this information is sent via the CAN to the instrument panel to light up the general failure warning light and show the information on the display. In the event of a failure, the control units should inhibit the automatic window raise movement.the windows are automatically opened or closed through the special prolonged (more than 2 seconds) command sent by the remote control button.The remote control receiver aerial is inside the ignition device (TEG Reader).The circuit is operated according to the luggage compartment junction unit control logic with a power supply protected by two special fuses operated by the underdashboard junction unit services relay: The rear electric window can be activated only with key-on (INT) except when the windows are closed/opened centrally via remote control and during the timed period with key off.During start-up, the relay is temporarily deactivated while with the ignition OFF, the Body Computer maintains the relay active for 2 seconds but deactivates it 30 seconds after opening one of the doors.The driver''s door control unit acquires both the driver''s front door and passenger side front door commands; it manages the movement of the driver''s window directly and sends the relevant movement commands for the passenger side window via the CAN to the passenger door control unit which manages the passenger side window directly.The passenger door control unit only acquires the commands for the front passenger door and controls its own motor directly.