194000383 - 1084A40 ENGINE OIL LEVEL SENSOR - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).
DescriptionConnector
-Battery    See A001 BATTERY
    Op. 4450B04 RIGHT FRONT WHEEL - R.R    Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.    Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.    Op. 2710A14 RIGHT DRIVESHAFT WITH JOINTS AND INTERMEDIATE DRIVESHAFT - R+R    Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R    Op. 1048B14 AIR DELIVERY HOSE BETWEEN TURBOCHARGER AND HEAT EXCHANGER - REPLACE    Op. 1084A16 OIL DIPSTICK PIPE - R.R    Op. 1092G10 SINGLE ENGINE BELT - R.R    Op. 1092A10 CRANKSHAFT PULLEY - R + R    Op. 1020A20 CRANKCASE OIL SUMP - R.R CLEAN SURFACES FOR SEALANT APPLICATION1. Release the clip.2. Undo the bolts (2a) and remove the engine oil level sensor (2b).
Refitting ( Removing ) 1. Place the engine oil level sensor (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine oil level sensorBoltM12(crankcase sump side) 2.3 - 2.81.9 JTD 16v1.9 JTD 8v
2. Fasten the electrical connection for the engine oil level sensor using the clip.
    Op. 1020A20 CRANKCASE OIL SUMP - R.R CLEAN SURFACES FOR SEALANT APPLICATION    Op. 1092A10 CRANKSHAFT PULLEY - R + R    Op. 1092G10 SINGLE ENGINE BELT - R.R    Op. 1084A16 OIL DIPSTICK PIPE - R.R    Op. 1048B14 AIR DELIVERY HOSE BETWEEN TURBOCHARGER AND HEAT EXCHANGER - REPLACE    Op. 1076B72 INTERMEDIATE EXHAUST PIPE WITH HOSE SECTION - R+R    Op. 2710A14 RIGHT DRIVESHAFT WITH JOINTS AND INTERMEDIATE DRIVESHAFT - R+R    Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.    Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.    Op. 4450B04 RIGHT FRONT WHEEL - R.R    Op. 0010T11 ENGINE OIL - CHECK LEVEL AND TOP UP, IF NECESSARY    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.- Connect the negative battery terminal.- Remove the vehicle from the lift.