194000437 - 1820B56 RIGID PIPE FROM VIBRATION DAMPER TO SLAVE CYLINDER - R R

Removing ( Refitting )     Op. 5530B10 BATTERY - R+R    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R1. Disconnect the electrical connection from the ABS electronic and hydraulic control unit.

	Description	Connector
1	ABS control unit	See M050 ABS CONTROL UNIT

2. Undo the bolts fixing the A.B.S. hydraulic and electronic control unit mounting brackets. - Lift the A.B.S. hydraulic and electronic control unit, complete with mounting brackets, as much as necessary.1. Raise the retaining clip (1a) and disconnect the clutch hydraulic circuit vibration damper (1b), clutch master cylinder side.

Keep any brake-clutch fluid that comes out.

1. Lift up the clip (1a) and disconnect the flexible pipe from the vibration damper to the operating cylinder (1b), operating cylinder side.2. Release the flexible pipe from the vibration damper to the operating cylinder from the retaining band. - Remove the rigid and flexible pipes from the vibration damper to the operating cylinder complete with vibration damper.1. At the bench, lift up the clip (1a) and separate the vibration damper (1b) from the rigid pipe.2. Undo the connector and disconnect the rigid pipe from the vibration damper to the operating cylinder (2a) from the flexible pipe (2b). Refitting ( Removing ) - Connect the rigid pipe from the vibration damper to the operating cylinder to the flexible pipe and tighten the connector to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Flexible supply pipe to operating cylinder	Connector	-	(rigid pipe side)

- Connect the vibration damper to the rigid pipe and secure it using the clip.- Place the rigid and flexible pipes from the vibration damper to the operating cylinder complete with vibration damper back in their housing.- Fasten the flexible pipe from the virbration damper to the operating cylinder using the band.- Connect the flexible pipe from the vibration damper to the operating cylinder, operating cylinder side and fasten it using the clip.1. Fit the retaining clip (1a) fully, then fit the clutch hydraulic circuit vibration damper (1b) on the clutch master cylinder until the clip is properly attached. - Place the A.B.S. hydraulic and electronic control unit, complete with mounting brackets, in its housing.- Tighten the bolts fixing the A.B.S. hydraulic and electronic control unit mounting brackets to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
A.B.S. hydraulic and electronic control unit mounting brackets	Bolt	M8	(bodyshell side) 1.7 - 2.3

- Connect the electrical connection to the ABS electronic and hydraulic control unit.    Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY    Op. 0010T67 HYDRAULIC CLUTCH SYSTEM - BLEED AIR    Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R    Op. 5530B10 BATTERY - R+R